Deed of variation of s106 agreement dated 28th November 2013 and its subsequent modifications, attached to planning consent 11/2629/MFUL (Residential development of 59 dwellings), to revise the affordable housing mix from 11 affordable rent and 11 shared ownership units to 18 affordable rented and 4 shared ownership dwellings. | Validated: 11/06/2026
T1: Ash; remove to ground level, extensive Ash Die-back, dead.T2: Ash clump; 30% reduction of the crown to reduce the risk of failure due to ADB, to allow the tree/s to regenerate at a lower height. Max dia. cuts 100mm.T3: Ash; 30% reduction of the crown to reduce the risk of failure due to ADB, to allow the tree/s to regenerate at a lower height. Max dia. cuts 100mm.T4: Ash; remove to ground level, extensive Ash Die-back dead.T5: Ash clump; 30% reduction of the crown to reduce the risk of failure due to ADB, to allow the tree/s to regenerate at a lower height. Max dia. cuts 100mm.T6: Pine; crown clean to remove the lower dead limb and higher deadwood into the crown.T7: Ash; 30% reduction of the crown to reduce the risk of failure due to ADB, to allow the tree/s to regenerate at a lower height. Max dia. cuts 100mm.T8: Monterey Cypress; crown clean, deadwood removal over the shed/garage. | Validated: 11/06/2026
T1: Oak - crown lift to 3m from ground level by target pruning the lower limbs back into appropriate growth points. Radial crown reduction by up to 30% (see annotated photos), achieved with the largest branch reduction of less than 4m and diameter of cuts ranging from 10mm to 100mm. | Validated: 11/06/2026
T1: Western Red Cedar, multi stemmed dbh 800mm, crown raise to approximately 6m on the north and north western aspect, maximum pruning cuts of no more than 75mm. | Validated: 10/06/2026
Beech - minor prune back of lowest branches on eastern quadrant of lower crown to reduce heavy shading, reduce potential contact with structures and free-up sightline for estate driveway. | Validated: 09/06/2026
Unit 12Stuart WayHill Barton Business ParkClyst St MaryExeterEX5 1SD
County matter application to vary conditions 8 and 12 of planning permission DCC/4135/2019 to increase the approved throughput of the IBA facility from 90,000 tonnes per annum to 150,000 tonnes per annum at Rock Solid Processing Ltd | Validated: 09/06/2026
Minor amendment for 22/2307/MRES: Minor amendment to: 1) Realign the drainage pipes near the outfall from Basin 2C, with an additional manhole introduced. 2) Introduction of an additional pipe into Basin 2C, with an associated new headwall, to serve a dedicated pipe supporting outflows from Parcels TC1 and TC2. | Validated: 09/06/2026
T1, Monterey Cypress - remove cracked limb on south side back to trunk. Shorten back adjacent low limb on western side, over field with decay on top, by approximately 2m to lighten the load. Reason to lessen the likelihood of breaking and damage. | Validated: 08/06/2026
T1: Oak - crown lift to achieve a clearance of 4m from ground level via removal of the lowest second and third order branches. Making target pruning cuts of up to 70mm diameter. To increase light penetration and airflow beneath the canopy, improving growing conditions for the established shrub and planting below, whilst retaining the trees overall canopy and amenity value. Also, to allow pedestrian access under canopy without obstruction.T2: Oak - crown lift to achieve a clearance of approx 5.5m above ground level via removal of 5x lowest secondary branches. Making target pruning cuts of up to 80mm diameter. To increase light penetration and airflow beneath the canopy, improving growing conditions for the established shrub and planting below, whilst retaining the trees overall canopy and amenity value. Also, to allow pedestrian access under canopy without obstruction.T3: Norway Maple (Crimson King) - dismantle to ground level. This tree is suppressed by the adjacent Beech and Oak (larger established canopy trees) limiting it's future growth potential. Removal would reduce competition for light, moisture and nutrients, allowing the larger Beech and Oak to continue developing while improving the overall structure of the tree group.T4: Beech - crown lift to achieve a clearance of 5.5m from ground level via removal of 5x lowest branches, making target pruning cuts of up to 80mm diameter. To increase light penetration and airflow beneath the canopy, to provide appropriate clearance from the adjacent BT line and nearby summerhouse, reducing the likelihood of branch contact whilst retaining the trees overall canopy, health and amenity value.T5: Aspen - remove the 3 lowest branches on the northern aspect, making target pruning cuts of up to 75mm diameter. To provide appropriate clearance to the adjacent BT overhead line, reducing the likelihood of branch contact whilst retaining the trees overall canopy, health and amenity value. | Validated: 08/06/2026
T1: Oak - reduce lower limbs on the east side by up to 2-2.5m making cuts of approximately 80mm. Crown clean and cut away small growth near the powerlines approximately 40mm diameter. | Validated: 08/06/2026
Various works to restore building to residential use. Roof: replace roof with slate & on south elevation install PV slate; install 3no. rooflights on north elevation and 2no. rooflights on west elevation. Low wall to be removed to create opening between hall and living room; construct partition walls at ground floor to create storage and WC and at first floor to create ensuite. Widen existing opening & install double doors & replace 3no. windows on south elevation; infill stonework on west elevation; roof vent on north elevation; wall vent in west elevation; install woodburner flue; replace 2no. doors on east elevation & internal plastering; install air source heat pump; infill openings in ground floor north & west elevation & repair/rebuild existing side wall. | Validated: 08/06/2026
Erection of two residential buildings to provide five one-bedroom apartments with associated parking and landscaping at Solways, Lyme Road, Uplyme. | Validated: 05/06/2026
Remove existing oil tank in rear garden; install air source heat pump (ASHP) on rear elevation where existing vent and flue are situated; dimensions of ASHP 1050mm (W), x 1040mm (H), x 480mm (D). | Validated: 05/06/2026
T1, Sycamore: prune all parts of the tree for 90cm below the top of the wall, which are in contact with the wall to give 5cm clearance from the wall as measured from the northern side of the wall to facilitate repairs. | Validated: 05/06/2026
T1: Willow - Prune the branches overhanging the neighbours garden on the south side by up to 2m, with maximum diameter pruning cuts of 45mm. The works are illustrated on the attached annotated photo. | Validated: 05/06/2026
