T1, Blue Cedar - Crown reduction to retain a tree with a finished height of 12 metres and an approximate crown radius of 4 metres in line with previous application 15/0934/TRE.Reason: to maintain tree to appropriate size for location. | Validated: 14/07/2022
T1, Turkey Oak : remove first order branch at approximately 4m on N side; shorten back second and third order branches over the garden and neighbouring property by approximately 2m; shorten back over roof by approximately 2m to a natural pruning position. | Validated: 13/07/2022
T7, Pine : Fell.Reason: Tree grown substantially causing excessive shade resulting in plants and grass not growing. Tree leans and concern it could fail. | Validated: 13/07/2022
Removal of existing tennis courts, provision of underground swimming pool, gym and associated exercise space, laying out of terraced areas and provision of pergola, remodelling of some of the existing topography and provision of new hard and soft landscaping including significant tree planting to reflect historical landscape design here. | Validated: 12/07/2022
Removal of existing tennis courts, provision of underground swimming pool, gym and associated exercise space, laying out of terraced areas and provision of pergola, remodelling of some of the existing topography and provision of new hard and soft landscaping including significant tree planting to reflect historical landscape design here. | Validated: 12/07/2022
Holm Oak (1) : Raise crown to 5m above ground level; reduce crown on North and East sides by 2 to 2.5m and clear roof by 1.5m Holm Oak (2) : Remove 2 lowest 4" diameter branches on South side to effectively raise crown to 5.5m. Shorten branches above on South side by 2m Turkey Oak (3) : Remove the 2 lowest 6" diameter branches on South side at approximately 8m above ground level; shorten branches in mid crown above on South side by 2m Horse Chestnut (4) : Reduce main stem and side stem on South side by 4m in height; thin out crown by 15%Reason: Appropriate arb management. | Validated: 11/07/2022
T1 beech dbh 600mm, located in West corner of property by red brick wall, on western side over driveways raise crown to 5.5m pruning cuts of no more than 75mm on North side prune back to trunk 1 x first order branch approximately 130mm in diameter, to allow vehicles to get to property's without hitting Tree branches.T2 Oak dbh 1400mm, located next to T1 on on SW side of property, raise crown on SW side only over shared driveway to 5.5m pruning cuts of no more than 75mm to allow vehicles access to property's without hitting any branches. | Validated: 11/07/2022
Axe Valley Mini Travel26 Harbour RoadSeatonEX12 2NA
Demolition of existing STC store and Bus Garage on site to be replaced by 9 residential units with landscaped gardens and private parking. | Validated: 08/07/2022
T1, Oak : remove epicormic growth and branches on trunk only up to 5m; MDC 100MM; On the north eastern side of the tree are several lateral branches extending out over a small apple tree, that finish around 75 to 80% up to the total height of the tree, reduce the end loads on these branches by up to 1.5m MDC 100mm; Thin canopy by 10% MDC 75mm.Reason: Appropriate arb management. | Validated: 08/07/2022