University Of Exeter Engineering Research CentreAnning RoadScience ParkExeterEX5 2GD
Planning Application for the adjustment of positioning of external plant equipment and battery storage container from that approved under previous application 21/1699 to support fit out works on the ground floor at the University of Exeter, Engineering Research Centre, Anning Road, Exeter Science Park. | Validated: 08/12/2021
Removal of previous wooden decking area, replaced with patio area consisting of block wall and engineering operation of rubble infill, construction of raised decking area at the bottom of garden including integral timber frame pergola | Validated: 08/12/2021
Single-storey side and rear extension. Proposed side extension with eaves and ridge to match the existing house. Proposed rear extension to be flat roof with parapet walls to 3 sides. | Validated: 08/12/2021
Conversion of two existing redundant buildings into a home office and changing room, a swimming pool and outside kitchen in the garden. | Validated: 07/12/2021
Conversion of two existing redundant buildings into a home office and changing room, a swimming pool and outside kitchen in the garden. | Validated: 07/12/2021
Replace 2no. windows sash windows on ground floor front (east) elevation and open up existing fireplace in dining room and install log burner | Validated: 07/12/2021
Single storey side extension on south elevation to the main farmhouse including balustrading and handrails (revision to 21/1697/LBC) | Validated: 07/12/2021
Certificate of lawfulness to establish the use of land as garden for Crossways Cottage, which use has subsisted for several decades. | Validated: 06/12/2021
Conversion of roof space to habitable to include a rear dormer, part single part two storey rear extensions and erection of garage. | Validated: 06/12/2021
T1 - Portuguese Laurel - Height proposed to be reduced to height of nearby first floor window and then thinned appropriately.Reason for works:To contain the tree and keep it at a manageable size. | Validated: 06/12/2021
T1, Silver Birch - Crown reduce by no more than 3.5m and reshape leaving a balanced and uniform shape as shown by the red line in the attached picture. Maximum diameter of cuts no more than 55mm. Reason: Appropriate arboricultural management to reduce risk of limb failure following previous poor arboricultural works. | Validated: 06/12/2021
Two storey side extension, single storey front extension and part conversion of garage to habitable use with alterations to fenestration. | Validated: 06/12/2021
Replacement Garage to the front of the property. Summer room to replace existing conservatory at the rear. Over cladding and render to existing walls. | Validated: 03/12/2021